Reference number
ISO/TR 11583:2012
Technical Report
ISO/TR 11583:2012
Measurement of wet gas flow by means of pressure differential devices inserted in circular cross-section conduits
Edition 1
2012-04
Technical Report
Preview
ISO/TR 11583:2012
50609
No disponible en español
Publicado (Edición 1, 2012)
Esta publicación se revisó y confirmó por última vez en 2022. Por lo tanto, esta versión es la actual.

ISO/TR 11583:2012

ISO/TR 11583:2012
50609
Idioma
Formato
CHF 129
Convertir Franco suizo (CHF) a tu moneda

Resumen

ISO/TR 11583:2012 describes the measurement of wet gas with differential pressure meters. It applies to two-phase flows of gas and liquid in which the flowing fluid mixture consist of gas in the region of 95 % volume fraction or more. ISO/TR 11583:2012 is an extension of ISO 5167. The ranges of gases and liquids from which the equations in ISO/TR 11583:2012 were derived are given. It is possible that the equations do not apply to liquids significantly different from those tested, particularly to highly viscous liquids.

Although the over-reading equations presented in ISO/TR 11583:2012 apply for a wide range of gases and liquids at appropriate gas-liquid density ratios, evaluating gas flow rates depends on information in addition to that required in single-phase flow: a measurement of the pressure loss can be sufficient; measurement of the liquid flow using tracers can be possible; the total mass flow rate may be known (this is more likely in a wet-steam flow than in a natural gas/liquid flow); in a wet-steam flow a throttling calorimeter can be used.

Wet-gas measurement using Venturi tubes or orifice plates is covered in ISO/TR 11583:2012.

Informaciones generales

  •  : Publicado
     : 2012-04
    : Norma Internacional confirmada [90.93]
  •  : 1
     : 26
  • ISO/TC 30/SC 2
    17.120.10 
  • RSS actualizaciones

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia