Final Draft
International Standard
ISO/FDIS 7801
Metallic materials — Wire — Reverse bend test
Reference number
ISO/FDIS 7801
Edition 2
© ISO 2024
Final Draft International Standard
Under development
This draft is in the approval phase.
Will replace ISO 7801:1984

Abstract

Specifies the method for determining the ability of wire of diameter or thickness 0,3 to 10 mm inclusive to undergo plastic deformation during reverse bending. The range of diameters of thicknesses for which ISO 7801 is applicable may be more exactly specified in the relevant product standard. The test consists of repeated bending, through 90 in opposite directions, of a test piece held at one end, each bend being over a cylindrical support of a specified radius.

General information

  • Status
     : Under development
    Stage
    : Proof sent to secretariat or FDIS ballot initiated: 8 weeks [50.20]
  • Edition
     : 2
    Number of pages
     : 9
  • Technical Committee :
    ISO/TC 164/SC 2
    ICS :
    77.040.10 
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. 77
  6. 77.040
  7. 77.040.10
  8. ISO/FDIS 7801