Status : Under development

Abstract

The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

General information

  • Status
     : Under development
    Stage
    : Working draft (WD) study initiated [20.20]
  • Edition
     : 2
  • Technical Committee :
    ISO/TC 138/SC 5
  • RSS updates

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goal

9
Industry, Innovation and Infrastructure

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Store
  3. Standards catalogue
  4. ICS
  5. ISO/WD 2507-1